top of page
.png)
Drawer Rails have various mounting locations, so we are going to ensure you get a proper location mark that doesn't interfere with the drawer rails.
Low mounted rail
Mid mounted rail
1. Make sure you are using the same base as the inside cabinet to do this installation.
2. Place the stencil on the bottom, and tape into place. Mark the center dot on a FlatPipe adapter and tape piece above/below rail, leaving about 1/2" gap. Note which gridline lines up to the center dot.
* Write number on stencil to reference later
1. Place stencil in position on the bottom of the cabinet and push all the way into the back corner of the cabinet and tape into position.
4. Cut the stencil flush with the face of the cabinet.
5. Measure from the floor up to the centering gridline. Write the number on the stencil to reference later.
* Notice that I had to pull out the drawer to get flush with to cabinet to get an accurate measurement.
6. Now tape the stencil on the outside of the cabinet (toilet side). measure for proper height and against the wall.
7. This cabinet has a leg feature that extends all the way up the side. Simply cut the stencil flush and retape into position.
* If your cabinet is flush, skip these 2 steps and go to step 9.
8. measure and tape the stencil into position to continue the guide line.
9. Drill pilot hole using small bit.
10. Remove template and drill larger hole using 1-3/4" hole saw bit.
11. Trim hole with razor blade.
12. Now we can make install the Drawer Kit. Tape the inside corner pieces into place
13. When measuring for the FlatPipe, only measure from the connection point, not the end.
14. Measure from A to B. Cut a piece of FlatPipe. Assemble ends and tape into position.
15. Assemble the Pass-through connectors and install both sides. Orient pieces to proper direction.
Both sides = 2X
-
2 FlatPipe Adaptors (Rear)
-
1 SquarePipe M/M
-
1 SquarePipe M/F
16. Measure from A to B. Cut a piece of FlatPipe, Install. Do both sides.
17. Drawer Kit complete.
Now we go back to Plumbing Installation.
Next Step:
3. Motor Installation.
.png)
18.
19.
20.
bottom of page