.png)
Prep the Cabinet/Drawer etc..
To make your install as easy as possible, Let's get everything out of the way.
1. Cabinet
Let's start with a clean slate.
-
Remove the cabinet doors.
-
Remove all supplies inside the cabinet.
-
Turn off both hot and cold water supply lines.
​
1. when removing the cabinet doors, remove the mounting screws and not the adjustment screws.
2. Remove all supplies, containers, mats, etc...
.jpg)
3. Don't forget to turn off both water supply lines. Just as a precaution.
2. Remove Drawers
If you have Drawers on the toilet side, we will need to remove them too.
-
Mark order drawers are removed.
-
To Remove drawer, pull drawer out to fully extend slides to expose the release levers. Push lever down and pull drawer out of slider.
-
NOTE - Some slides release levers are a little tricky, on one side the lever might lift UP and the other side you might need to press DOWN.
-
Some Drawer slides have a wheel that drops into a track.
-
Some Drawer slides have a Tab that you push into release the drawer.
1. Pull drawer all the way out to expose the release levers, located on the inner slides.
2. lift one lever up and the other press down, than pull the drawer out of the slide rails. Push the exposed slides back into the cabinet for safety.
3. Some drawers have a drop-down rail system.
3. Toilet Setup
The OARYsystem vacuum plate sits between the toilet seat and the toilet bowl.
-
Remove Toilet seat.
-
Sanitize area.
1. Remove toilet seat by unscrewing the two mounting bolts at the top of the seat. Most bolts have a cover you need to remove to expose the bolt.
2. Sanitize the area with bleach.
.png)
3.